Question

Начерти в тетради отрезок как показано на рисунке это одна из сторон квадрата дострой квадрат с помощью угольника и линейки Начерти отрезок и еще раз и построй прямоугольник

Answer 1

Где рисунок???????????????????

Answer 2

Drawing a Line Segment

To draw a line segment as shown in the diagram, follow these steps:

1. Start by drawing a point on the paper. This will be one of the endpoints of the line segment. 2. Using a ruler, draw a straight line from the point you just drew. This line will represent the line segment. Make sure the line is straight and extends in the desired direction. 3. Measure the length of the line segment using the ruler. Take note of the measurement.

Completing the Square

To complete the square using an angle ruler and a straightedge, follow these steps:

1. Start with the line segment you just drew. This will be one side of the square. 2. Place the angle ruler on one endpoint of the line segment, aligning one of its edges with the line segment. 3. Using the straightedge, draw a line segment that intersects the other endpoint of the original line segment. This new line segment should be perpendicular to the original line segment and should have the same length as the original line segment. 4. Connect the endpoints of the two line segments you just drew to form a square.

Drawing a Rectangle

To draw a rectangle, follow these steps:

1. Start with the square you just drew. This will be one of the sides of the rectangle. 2. Using the ruler, measure the length of one side of the square. Take note of the measurement. 3. Place the ruler on one of the corners of the square and draw a line segment that extends in the desired direction. This line segment will be one side of the rectangle. 4. Using the ruler, measure the width of the rectangle. Take note of the measurement. 5. Place the ruler on the endpoint of the line segment you just drew and draw another line segment that is perpendicular to the first line segment. This line segment will be the other side of the rectangle. 6. Connect the endpoints of the two line segments you just drew to form a rectangle.

Remember to use the measurements you took earlier to ensure the sides of the rectangle are the correct length.

I hope this helps! Let me know if you have any further questions.